8.14. Airsupercharger

Removal and installation
1. Disconnect a wire block from the resistor.
2. Unscrew three screws and remove from a mouth of the airsupercharger an aperture nastavka together with a sealant.

Fig. 8.35. Airsupercharger: 1 – the case is left; 2 – the case is right; 3 – latch; 4 – fan peak left; 5 – fan peak right; 6 – fan; 7 – the plug is sealing; 8 – paper clip; 9 – the nut is lamellar; 10 – plug; 11 – washer; 12 – bolt


3. Turn off nuts (fig. 8.35) from the left and right points of fastening and remove the airsupercharger.
4. Establish the airsupercharger upside-down.

Dismantling and assembly
1. Remove a spring paper clip 8 (see fig. 8.35) and separate peaks of the 4 and 5 fan.
2. Turn off two bolts of the 12th fastening of the fan.
3. Remove spring latches 3, separate the left part of 1 case from right 2 and take out the fan 6.
4. Collect the airsupercharger upside-down.